![]() |
![]() |
#1 |
Benutzer
![]() Registriert seit: 17.12.2019
Ort: Volos
Beiträge: 82
|
![]()
Hello i changed spark in L701 and i noticed that in white part of spark was an oily.Is this a problem?
How i can fixed it? Thanks |
![]() |
![]() |
![]() |
#2 |
Vielposter
![]() Registriert seit: 20.07.2008
Ort: Mittelfranken / Fränk. Seenland
Beiträge: 2.050
|
![]()
There is a rubbergasket inside the valve cover - heat, age and oil destroy it over the years ... better look for another valve cover to fix that problem .
Greetings Mo .
__________________
MOCCA ! MO`s Cuore Custom Association Collect them all ![]() ![]() ![]() ![]() |
![]() |
![]() |
![]() |
#3 |
Erfahrener Benutzer
![]() Registriert seit: 07.12.2018
Ort: Wutöschingen
Beiträge: 1.104
|
![]() |
![]() |
![]() |
![]() |
#4 |
Benutzer
![]() Registriert seit: 17.12.2019
Ort: Volos
Beiträge: 82
Themenstarter
|
![]()
Oily spark not in thread but in white end.
I notices 3 orings in valve cover? |
![]() |
![]() |
![]() |
#5 |
Erfahrener Benutzer
![]() Registriert seit: 07.12.2018
Ort: Wutöschingen
Beiträge: 1.104
|
![]()
I see, now. The oil film is found on the engine's exterior. The rubber gaskets tend to become brittle. I had to replace mine also. They are not expensive
|
![]() |
![]() |
![]() |
#6 |
Benutzer
![]() Registriert seit: 17.12.2019
Ort: Volos
Beiträge: 82
Themenstarter
|
![]()
Yes but except of the rubber gasket there are and o rings rubber in spark plugs?
|
![]() |
![]() |
![]() |
#7 |
Erfahrener Benutzer
![]() Registriert seit: 07.12.2018
Ort: Wutöschingen
Beiträge: 1.104
|
![]()
No. The sparkplugs use a metal gasket. The oil is likely seeping out from one or both valve covers and is settling around the lowest point which is the sparkplug area. This was a typical fault with a similar FIAT design
![]() |
![]() |
![]() |
![]() |
#8 |
Benutzer
![]() Registriert seit: 17.12.2019
Ort: Volos
Beiträge: 82
Themenstarter
|
![]()
Ok.Very beautiful motor.
If i want to not have oily spark i must change only the cover gasket? |
![]() |
![]() |
![]() |
#9 |
Erfahrener Benutzer
![]() Registriert seit: 07.12.2018
Ort: Wutöschingen
Beiträge: 1.104
|
![]()
Yes. Before you remove the sparkplugs, you should apply solvent sourounding the plugs. Then, blow away the solvent and oil, using compressed air. Otherwise, you will risk debris entering the cylinder when the sparkplug has been removed
|
![]() |
![]() |
![]() |
#10 |
24/7 Poster
![]() Registriert seit: 05.12.2006
Ort: Menznau LU/CH
Alter: 44
Beiträge: 6.930
|
![]()
As long as the Ignition works, you can save the money. On my L251 (same engine), I had always some Oil on top of the Spark Plugs. Never had an Issue with that.
As far as I know, there is pretty much no EJ-engine, which doesn't have that Oil seal leak against the spark plug, no matter if new or old. Just wipe the Spark plug connector clean when it has been taken out.
__________________
Cuore L251 Bj 7/2003, Automatik: ![]() Citroen C1 Automatik BJ 2011: ![]() Mofa: Dreirad auf Basis eines Amsler-Pony, Verbrauch Zweitaktgemisch: <3.5l/100km. Das grosse Artensterben auf dieser Welt wird den Menschen erst bewusst werden, wenn schliesslich auch der Tiger im Tank ausstirbt. |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thema | Autor | Forum | Antworten | Letzter Beitrag |
Nissan Altima 2.5S - Spark Plugs Issue | depprussell | Allgemein | 1 | 05.07.2018 08:56 |